Aerospace series. Bolts, normal hexagonal head, close tolerance normal shank, short thread, in alloy steel, cadmium plated. Classification: 1100 MPa (at ambient temperature) / 235°C

This International Standard specifies requirements for reciprocating positive-displacement pumps and pump units for use in the petroleum

BS EN ISO 15118‑8:2019 supersedes BS ISO 151188:2018

It is an updated supplement to BS EN 62305-2 which provides a procedure for assessing the risk to a structure or service from lightning flashes to earth

taking the place of oxygen

What is ISO 3838 - Determination of the density or relative density of crude petroleum and of petroleum products about

measured with the eyes in the primary position

passenger and goods lifts – before they’re put into service

BS 6200-5 gives guidance on the statistical procedures used during the development of methods for the analysis of iron and steel

BS ISO 27892 specifies a method for the measurement of rapid shutdown torque (destructive torque) of turbomolecular pumps in which gas momentum is produced by axial flow type blades and/or helical channels

ISO 10005 uses the term “specific case”

This helps in determining the electrical properties of clad and unclad materials used in printed boards

5 L maximum single flush