1965-68 Chevrolet Corvette Power/Manual 3/16" Rear Trailing Arm Brake Lines w/Spring Wrap 2pc, OE SteelThese preformed brake lines will replace the lines that are on the rear axle housing trailing arms on your vehicle and run from hose to hose or hose to wheel. We engineer our replacement lines from factory original lines and CNC manufacture them for precision. They include the correct fittings, flares, and protective wrap (where equipped). Clip sets, hoses, and valves are available for most lines and can be found in the related products below or by

This clip kit includes all clips necessary to secure the brake lines to the chassis of the car: four R style clips

1964-67 Chevrolet Chevelle El Camino Small Block Manual Transmission Counter Shaft Z-Bar 1 PC

1968-72 Olds Engine Alternator Mounting Bolt Kit All V8 With AC

and 455 HO/SD

1967-68 Chevrolet Impala Caprice Factory 4 Piston Disc Brake Stainless Braided Brake Hose Kit 3pc

Inline Tube’s Dual Master Cylinder Upper Conversion Kits have every brand-new factory-style component required at the firewall to convert to a dual reservoir master cylinder

100% like the original in fit and finish

1967-78 Pontiac Engine Timing Chain Cover Bolts & Washers Lower 4pc

1967-69 Pontiac/Buick/Olds Shifter Support Bracket Bolst & Washers 6pc

Please note that this valve uses a single-pin brake light switch

Hose may need to be shortened

This assembly includes a 4” hose with -3AN female fittings on each end