Shell mill holder SK 50 - 32 - 40Application: For mounting milling cutters with transversal groove. Note: d = 40 d = 60: For large diameter face mill cutters with four additional threaded holes according to DIN 2079. SK 30 without coolant exit bores on the end faceDelivery: With drivers, cross head retaining screw and cylinder head retaining screw for cutters with central coolant. For d = 60 only with four fi xation screws according to DIN 912. All holders are made of forged steel

- mobility allows measuring within machines and fixtures

For mounting straight-shank tools in collets

(applicable up to 21 bar)

130 x 46 x 15

Positionier- und Halte-Pin

Dial Graduation: 1°

Thread configuration with a special design

- four measuring methode: standard

With clamping screw and axial adjustment bolt

Wherever reduced interference contours are required

Nubs on the top of the inserts

- With data output interface