Rack mount for Home Assistant Blue (Modular)3D Printed 1RU rack mount for the Home Assistant Blue. This is part of our ModMount Range, so you can mix and match your parts! This item is Omni directional, so you can use it on the left or right side. NOTE: You will need to pair this with another ModMount item (Like a Blanking Plate) to make a full 1RU Width, screws are included to join the parts. The Home Assistant Blue slides into the frame from the back after removing the back plate. Note, this

3D Printed rack mount for the ARRIS SURFboard SB8200 / SB6190 / SB6141 Cable Modem as well as the NBN CM8200 HFC Modem

The UXG-Lite slides into the frame from the front

3D Printed 1RU rack mount for the Somfy Systems TaHoma switch

something else from the ModMount range

3D Printed rack mount that lets you mount 3x Sonos Ports next to each other into a standard 19 Inch Rack taking only 2RU

Each "Socket" has the following dimensions:

and running smoothly with Hive Tech Solutions' 3D Printed Noctua A14 140mm Fan Stand

The frame comes in 3 parts and the sides are connected to the main body with 10 Screws (Included)

If you are using the POE+ Hat

Your NUC's will slide into the unit from the front and there are holes on the bottom that line up with the mounting holes if you want to fasten the NUCs to the mount

Your NUC's will slide into the unit from the front and all cables are accessible from the rear

You can even use this to mount 2 of these NUCs into a 1RU space