Plastics piping systems for renovation of underground drainage and sewerage networks under pressure - Lining with continuous pipes1 Scope This document, in conjunction with ISO 112971, specifies requirements and test methods for pipes and fittings which are part of plastics piping systems installed as continuous pipes in the renovation of underground drainage and sewerage networks under pressure. It is applicable to polyethylene (PE) pipes of three different types: PE solid wall single layered pipes (nominal outside diameter, dn), including any identification stripes; PE pipes

and gives methods of testing

Users intending to adopt any of these recommendations for old roofs

of PB monolayer

This International Standard describes fundamental concepts related to the effective use of terminological data

(for example

and environmental performance requirements of a terminated and assembled Single mode MF 4-fold-connector set

BS EN 473:2008 replaces the withdrawn BS EN 473:2000 standard

Figure 2 and Figure 3

Why should you use BS EN 1028-2 - Safety requirements for fire-fighting centrifugal pumps with primer

BS EN 2436-002 provides users references on environmental characteristics

Annex A is informative

mobile patrols