End mill holder Weldon BT 30 - 18 - 63Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

The steel body is hardened and grinded all-round

Ergonomic Handle of Design

shank form UF

- Bed height H: 0

Powder-coated

With clamping screw and O-ring

For mounting and drifting taper shanks DIN 228-1 A in toolholders DIN 228-1 B

For mounting straight-shank tools and inclined flat according to DIN 1835 form E (Whistle Notch)

Stahlkörper allseitig geschliffen und gehärtet

Clamping positions: horizontal and vertical

4 und 5 mm = h4

Resolution: