Plastics. Determination of mode I plane-strain crack-arrest toughness1 Scope This International Standard specifies a method for the determination of the plane strain crack arrest fracture toughness, Kla, of polymeric materials by using a side grooved, crack line wedge loaded compact tension specimen to obtain a rapid crack run arrest segment of flat tensile separation with a satisfactory crack front. This International Standard employs a static fracture analysis determination of the stress intensity factor at a short

The aim of the BS EN 13990 is to provide manufacturers with characteristics of the solid softwood floor boards that helps in grading their product

An electrical test is useful in ensuring the capacity of these cables

BS EN 50342-3:2008 Lead-acid starter batteries

leather products meant for children are required to have lower formaldehyde content compared to products meant for adults

BS EN 4057-406 specifies the procedure for measuring the force required to pull out the metallic locking device from the head of the cable tie when the force is applied in the manner specified

- Negative control

The scrap category (scrap consisting of skimmings

Materials for use specifically in utility power cables are not covered by this EN

primarily for usage at or near the coalface

BS ISO 6732 is an International Standard which specifies a spectrometric reference method for the determination of the iron content of milk and milk products

including safety recommendations

Introduction of new terminology