Pitman Arm for Clipper Models 49D & 498DThis pitman arm goes on the 49D and 498D models. It may fit other clipper models as well. You will have to reference the part numbers listed in your parts book. This part is used to connect the eccentric shaft to the shoe of the seed cleaner. Note that right hand and left hand are determined by facing the end of the cleaner where you insert the screens. Note: If you have a clipper pitman arm that is not listed in our store you can ship us your used

For brush drive on E-224 & updated M2Bs

This is the Clipper factory made bushing for Clipper X 29Ds

Clipper AGM 224

two pillow block bearings

This pitman arm is for 288

Eccentric bearing for E224

Choose RIGHT or LEFT in the drop box box

Screen measure 17” X 6”

It is 1” bore

5 inches wide

The Clipper part number is F117-00200

F196-00002 Clipper 29D & 298D LH bottom shoe